Khác biệt giữa các bản “Viết thử”
Từ ChipFC Wiki
(Tạo trang mới với nội dung “== Công thức toán học == <math> \operatorname{erfc}(x) = \frac{2}{\sqrt{\pi}} \int_x^{\infty} e^{-t^2}\,dt = \frac{e^{-x^2}}{x\sqrt{\pi}}\sum…”) |
|||
Dòng 41: | Dòng 41: | ||
== Danh sách bài viết == | == Danh sách bài viết == | ||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
<DynamicPageList> | <DynamicPageList> | ||
category=Bài viết hướng dẫn | category=Bài viết hướng dẫn | ||
− | count= | + | count = 5 |
− | + | order = ascending | |
− | + | addfirstcategorydate = true | |
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | order=ascending | ||
− | |||
− | |||
</DynamicPageList> | </DynamicPageList> |
Phiên bản lúc 11:32, ngày 9 tháng 2 năm 2014
Công thức toán học
<math>
\operatorname{erfc}(x) = \frac{2}{\sqrt{\pi}} \int_x^{\infty} e^{-t^2}\,dt = \frac{e^{-x^2}}{x\sqrt{\pi}}\sum_{n=0}^\infty (-1)^n \frac{(2n)!}{n!(2x)^{2n}}
</math>
$
\sum f(x) = F(x) + g(x)
$
Mã nguồn
/*
Blink
Turns on an LED on for one second, then off for one second, repeatedly.
This example code is in the public domain.
*/
// Pin 13 has an LED connected on most Arduino boards.
// give it a name:
int led = 13;
// the setup routine runs once when you press reset:
void setup() {
// initialize the digital pin as an output.
pinMode(led, OUTPUT);
}
// the loop routine runs over and over again forever:
void loop() {
digitalWrite(led, HIGH); // turn the LED on (HIGH is the voltage level)
delay(1000); // wait for a second
digitalWrite(led, LOW); // turn the LED off by making the voltage LOW
delay(1000); // wait for a second
}
Danh sách bài viết
- 2014-02-09: Bắt đầu với Arduino
- 2014-02-24: Thư viện Arduino
- 2014-03-08: Lập trình Arduino
- 2014-10-30: Hướng dẫn cài đặt FTDI Driver bằng tay
- 2014-11-18: Ngôn ngữ Arduino