Chipi - Button
Từ ChipFC Wiki
Bài viết này đang được phát triển hoặc chỉnh sửa lớn. |
Giới thiệu
ChipI - Button trên trang chủ
ChipI Button Top.jpgChipI Button Bot.jpg
ChipI - Button là một mô-đun có một nút nhấn thuộc dòng sản phẩm Chipi của ChipFC. Đầu ra là rào cắm 4 chân tương thích với Chipi Base Shield. Đây là giải pháp nhanh chóng và tiện lợi cho người làm đồ tự chế.
Đặc điểm
- Có trở kéo lên
- Tích cực mức thấp. Tức là khi không được nhấn nút thì tín hiệu ra ở mức cao, khi nhấn nút tín hiệu ra ở mức thấp
- Kích thước: 2.54mm x 2.54mm
Kết nối
Thứ tự chân | Tên gọi | Loại | Mô tả |
---|---|---|---|
1 | VCC | Power | Điện áp dương 3.3V hoặc 5V. |
2 | GND | Power | Điện áp âm 0V |
3 | SIG | Output | Tín hiệu ra của nút nhấn |
4 | X | NC | Không sử dụng |
Sử dụng
Below is a simple example showing how to use a button to turn on/off an LED.
//Turns on and off a light emitting diode(LED) connected to digital pin 13, when pressing a pushbutton attached to pin 2.
/*
The circuit:
* LED attached from pin 13 to ground
* pushbutton attached to pin 2 from +5V
* 10K resistor attached to pin 2 from ground
* Note: on most Arduinos there is already an LED on the board
attached to pin 13.
This example code is in the public domain.
http://www.arduino.cc/en/Tutorial/Button
*/
// constants won't change. They're used here to
// set pin numbers:
const int buttonPin = 2; // the number of the pushbutton pin
const int ledPin = 13; // the number of the LED pin
// variables will change:
int buttonState = 0; // variable for reading the pushbutton status
void setup() {
// initialize the LED pin as an output:
pinMode(ledPin, OUTPUT);
// initialize the pushbutton pin as an input:
pinMode(buttonPin, INPUT);
}
void loop(){
// read the state of the pushbutton value:
buttonState = digitalRead(buttonPin);
// check if the pushbutton is pressed.
// if it is, the buttonState is HIGH:
if (buttonState == HIGH) {
// turn LED on:
digitalWrite(ledPin, HIGH);
}
else {
// turn LED off:
digitalWrite(ledPin, LOW);
}
} |